Important: DO NOT use a hard-to-remember password here! I recommend using abc123 as a password and writing it down just in case. This will show a prompt to set a supervisor password. Go to the Security page and navigate to Set Supervisor Password. In order to change it you need to temporarily set a supervisor password in the BIOS. When accessing the BIOS/UEFI by pressing the F2 key during boot, the Secure Boot option is and greyed out so I couldn’t change it. However, this may change when the final version is released.On my Acer Aspire A515-52-51EL Secure Boot is enabled by default. It's important to note that doing the development process, Microsoft is not fully enforcing all the system requirements.
Press the required key repeatedly until you enter the setup mode.See the screen splash to identify the key you must press to enter the firmware (if applicable).To access the device firmware during the boot process, use these steps: Confirm the changes to restart the computer.Īfter you complete the steps, the security feature will enable, and the device should now comply with the Windows 11 requirements.Īlternatively, you can also enable Secure Boot by booting into the UEFI firmware during startup instead of using the Settings app.Select the Enabled option and press Enter.
Select the Secure Boot option and press Enter.As a result, you may need to check your manufacturer support website for more specific details to find the corresponding settings. Quick note: The UEFI settings are usually different per manufacturer and even per computer model. Quick tip: If you have a legacy BIOS, the option will not be available. Under the "Advanced startup" section, click the Restart now button. The process to convert the drive partition should not affect the installation, but it's always recommended to create a backup before proceeding.
If you are trying to do a clean install of the new version, you don't need the converstion, but you must go through the converstion when trying to do an in-place upgrade. If the computer is still in the legacy BIOS, you will first need to convert the drive using MBR to GPT. Also, the steps below assumes the device is already running on UEFI. It's assumed that you know what you're doing. You should access the motherboard settings only when you have a good reason. Warning: Changing the incorrect firmware settings can prevent your device from starting correctly. To enable the Secure Boot on a computer with UEFI, use these steps: If the "Secure Boot State" is set to Off and "BIOS Mode" to Legacy, then back up your computer, use these instructions to convert the installation from MBR to GPT, and then continue with the steps below to enable Secure Boot. Once you complete the steps, if the feature is disabled and BIOS Mode is UEFI, you can use the steps outlined below to enable a more secure experience running Windows 11. If it is reads Legacy (BIOS), you can enable the feature, but it will require additional steps. If it is reads UEFI, you can enable Secure Boot. If it reads Off, it's disabled or not available. Click on System Summary on the left pane.Ĭheck the "Secure Boot State" information.Search for System Information and click the top result to open the app.To check whether Secure Boot is enabled, use these steps:
How to check Secure Boot state on Windows 10 How to enable Secure Boot during startup.How to enable Secure Boot on Windows 10.How to check Secure Boot state on Windows 10.
In this Windows 11 guide, we will walk you through the steps to check and enable Secure Boot to upgrade a Windows 10 device.